Ticket: CM-4859, CM-4382
Reviewed By:
Testing Done: Tested with config which included bond bridge ports with
zero address on the bond.
The bridge driver rejects the port add with -EINVAL.
A bond with no slaves is one usecase where the bond interface
has a zero hw address and is rejected by the bridge.
EINVAL currently is very confusing.
This patch checks for a valid ether add before enslaving the port to the
bridge.
Ticket: CM-4802
Reviewed By:
Testing Done: yes
1. clag_enable needs to be set before slaves are added to the bond. Otherwise
bonding driver will bring the slaves up independent of clagd.
2. also added post_down clagd addon to cleanup the clag-id on ifdown.
Ticket: CM-4802
Reviewed By: CCR-2507
Testing Done: Yes
1. For clag bonds the slaves are kept down under various conditions (when clagd
is holding the bond in an errDisabled state). ifupdown2 should not set the slave
states for clag bonds.
2. Bonding driver sets the slave states on enslave and release (also for
non-clag bonds) so ifupdown2 doesn't need to set the slave state.
Ticket: CM-4723
Reviewed By: CCR-2408
Testing Done: vxlan_fld_test.py:test_bond_vxlinux_convergence_flaps, manual testing
On tunnel delete, tunnel termination object in BCM sdk is not cleaned properly.
As a result, mpls_entry in the hardware is left around even though software has
deleted the tunnel. This prevents subsequent dynamic creation of the same tunnel
and also mac learning, as mpls_entry points to invalid SVP with no CML setting
to do hardware learning.
Also, changes in ifupdown2 to make "vxlan-learning on" as default, so that
user/script doesn't have to explicitly turn on the learning.
Ticket: CM-4639
Reviewed By:
Testing Done: Tested with interfaces file and steps from the bug
This is a Hack to make sure the primary address
is the first in the routing table. Its not a full proof solution.
We use `ip route get` on the vrr network to see which
device the kernel returns. if it is the mac vlan device,
flap the macvlan device to adjust the routing table entry.
flapping the macvlan device makes sure the macvlan
connected route goes through delete + add, hence adjusting
the order in the routing table.
1. clag_enable flag in the bonding driver
2. And clagid in clagd
Ticket: CM-4091
Reviewed By:
Testing Done: yes
1. Two new commands have been introduced in clagctl - setclagid and showclagid.
These commands will be used by ifupdown2 to set and read/check the clagid.
2. In addition a bit will be maintained per-bond in the bonding driver to
indicate if a bond is a CLAG bond.
(cherry picked from commit cb160bad45d330fe5f544d0d9a40c1c77b9b563f)
Ticket:
Reviewed By:
Testing Done: Yes
1. ifupdown2/bonding-driver changes to show/store clag-id (errDisabled/dormant states for bond slaves will follow in 2.5.1)
2. clagd changes for
a. --forceDynamic - clagid is ignored in this mode
b. (default) static mode - clagid is matched along with partner mac for dualConnection; also ad_sys_mac is only changed for clag bonds (bonds with a non-zero clag-id).
Conflicts:
patches/kernel/series
in vlan module to use rtnetlink api
Ticket: CM-4173
Reviewed By:
Testing Done: Tested new bridge driver svi up/down
This does not move all 'bridge vlan' commands to rtnetlink yet.
Ticket: CM-3346
Reviewed By:
Testing Done: Tested ifupdown2 sanity
- moved 'admin up' delays that we introduced recently to be
configurable via two ifupdown2.conf attributes
# Let link master (bridges, bonds) own the link state of slaves
link_master_slave=1
# Delay admin state change till the end
delay_admin_state_change=0
- reduced some redundant traversal of dependency trees
- fixed a few bugs in query check
issues with having it in flags) + add check for bond slave being already up
Ticket: CM-4408
Reviewed By:
Testing Done: some bond sanity test
(cherry picked from commit 346b62a41fbf4521008cd8a9b0fa227e75a5d994)
sure that slaves can never be brought admin up on their own when they
are not in the bond
Ticket: CM-4408
Reviewed By: CCR-2323
Testing Done: Tested ifup/ifdown of bond slaves and bond interface
This patch introduces:
- introduces 2 interface flags, LINK_MASTER and LINK_SLAVE.
- The bond module will set LINK_MASTER on the bond iface object
indicating that the bond module owns the link.
- Which means that all lower devices /slaves of the bond get their
link when the bond (aka LINK_MASTER) is processed in the bond module
- The module that queries dependencies propagates the LINK_SLAVE flags
on the dependents of LINK_MASTER.
- The scheduler now acts on the LINK_SLAVE flag. If LINK_SLAVE is set,
it skips setting admin 'up' on that interface. It also makes sure the
interface is not already in the bond.
ie if an interface is a LINK_SLAVE (bond slave in this case), admin
up will not be executed when the interface is not inside the bond.
(cherry picked from commit 84b5a07a4f7685c7ae2eac5892889d6c0e08b2eb)
sure that slaves can never be brought admin up on their own when they
are not in the bond
Ticket: CM-4408
Reviewed By: CCR-2323
Testing Done: Tested ifup/ifdown of bond slaves and bond interface
This patch introduces:
- introduces 2 interface flags, LINK_MASTER and LINK_SLAVE.
- The bond module will set LINK_MASTER on the bond iface object
indicating that the bond module owns the link.
- Which means that all lower devices /slaves of the bond get their
link when the bond (aka LINK_MASTER) is processed in the bond module
- The module that queries dependencies propagates the LINK_SLAVE flags
on the dependents of LINK_MASTER.
- The scheduler now acts on the LINK_SLAVE flag. If LINK_SLAVE is set,
it skips setting admin 'up' on that interface. It also makes sure the
interface is not already in the bond.
ie if an interface is a LINK_SLAVE (bond slave in this case), admin
up will not be executed when the interface is not inside the bond.
to return reserved vlan range from /etc/cumulus/switchd.conf
Ticket: CM-4367
Reviewed By: wkok
Testing Done: Tested using reserved vlans in old and new bridge
(cherry picked from commit 8626feb08703392b29e234b2f81f4df536ad7f7b)
to return reserved vlan range from /etc/cumulus/switchd.conf
Ticket: CM-4367
Reviewed By: wkok
Testing Done: Tested using reserved vlans in old and new bridge
Ticket: CM-4336
Reviewed By:
Testing Done: Tested with the missing port testcase from CM-4336
(cherry picked from commit 82a976ada6ba208bde089805d613413a5b016f8d)
over ifup handling of upperifaces by default) + some fixes in the
reserved vlan check
Ticket: CM-3346
Reviewed By:
Testing Done: Tested ifupdown sanity.
Ticket: CM-3454
Reviewed By:
Testing Done: basic testing with vrrpd
There is no check support yet and an open issue
with checking existing ifplugd processes
