mirror of
https://github.com/eworm-de/routeros-scripts.git
synced 2024-05-11 05:55:19 +00:00
44 lines
1.2 KiB
Markdown
44 lines
1.2 KiB
Markdown
|
Notify about health state
|
||
|
|
=========================
|
||
|
|
|
||
|
|
[◀ Go back to main README](../README.md)
|
||
|
|
|
||
|
|
Description
|
||
|
|
-----------
|
||
|
|
|
||
|
|
This script is run from scheduler periodically, sending notification on
|
||
|
|
health related events:
|
||
|
|
|
||
|
|
* voltage jumps up or down more than configured threshold
|
||
|
|
* power supply failed or recovered
|
||
|
|
* temperature is above or below threshold
|
||
|
|
|
||
|
|
Note that bad initial state will not trigger an event.
|
||
|
|
|
||
|
|
Only sensors available in hardware can be checked. See what your
|
||
|
|
hardware supports:
|
||
|
|
|
||
|
|
/ system health print;
|
||
|
|
|
||
|
|
Requirements and installation
|
||
|
|
-----------------------------
|
||
|
|
|
||
|
|
Just install the script and create a scheduler:
|
||
|
|
|
||
|
|
$ScriptInstallUpdate check-health;
|
||
|
|
/ system scheduler add interval=1m name=check-health on-event="/ system script run check-health;" start-time=startup;
|
||
|
|
|
||
|
|
Configuration
|
||
|
|
-------------
|
||
|
|
|
||
|
|
The configuration goes to `global-config-overlay`, These are the parameters:
|
||
|
|
|
||
|
|
* `CheckHealthTemperature`: an array specifying temperature thresholds for sensors
|
||
|
|
* `CheckHealthVoltagePercent`: percentage value to trigger voltage jumps
|
||
|
|
|
||
|
|
Also notification settings are required for e-mail and telegram.
|
||
|
|
|
||
|
|
---
|
||
|
|
[◀ Go back to main README](../README.md)
|
||
|
|
[▲ Go back to top](#top)
|