librenms-librenms/doc/Support/Install Validation.md

# Install validation

With a lot of configuration possibilities, manually editing config.php
means it's not uncommon that mistakes get made. It's also impossible
to validate user input in config.php when you're just using a text
editor :)

So, to try and help with some of the general issues people come across
we've put together a simple validation tool which at present will:

- Validate config.php from a php perspective including whitespace
  where it shouldn't be.
- Connection to your MySQL server to verify credentials.
- Checks if you are running the older alerting system.
- Checks your rrd directory setup if not running rrdcached.
- Checks disk space for where /opt/librenms is installed.
- Checks location to fping
- Tests MySQL strict mode being enabled
- Tests for files not owned by librenms user (if configured)

Optionally you can also pass -m and a module name for that to be
tested. Current modules are:

- mail - This will validate your mail transport configuration.
- dist-poller - This will test your distributed poller configuration.
- rrdcheck - This will test your rrd files to see if they are
  unreadable or corrupted (source of broken graphs).

You can run validate.php as `root` by executing `./validate.php`
within your install directory.

The output will provide you either a clean bill of health or a list of
things you need to fix:

**OK** - This is a good thing, you can skip over these :)

**WARN** - You probably want to check this out.

**FAIL** - This is going to need your attention!

# Validate from the WebUI

You can validate your LibreNMS install from the WebUI, using the nav
bar and clicking on the little Gear Icon -> Validate Config. 

![Validate Config Icon](/img/validate-config-icon.png) 

Then You should see the results of validate.

Below is just example of the results.

![Validate results](/img/validate-results.png)